6. With no path failure, what controls automatic path switching in an active/active MSA1500 controller
configuration?
A. MSA controller firmware, not configurable
B. Fibre Channel I/O modules, not configurable
C. MSA controller firmware, user can set thresholds
D. Fibre Channel Fabric switches, user can set thresholds
Answer: C
7. Using the Command Line Interface, which command is used to add space to a specific LUN on an MSA1000?
A. SET UNIT
Pass4Side HP HP0-J23
Pass4Side Help you pass any IT Exams! Page 3 of 5
B. ADD UNIT
C. EXTEND UNIT
D. EXPAND UNIT
Answer: C
8. What is used to launch Secure Path Manager?
A. http://localhost:2381
B. http://localhost:7902
C. StorageWorks Command Console client
D. Secure Path Manager local program group
Answer: A
9. What are three purposes of ACL in an MSA1000/1500 cs Command Line Interface? (Select three.)
A. to disable access of logical drives to all connected servers
B. to allow spares to be associated with specific arrays
C. to allow access of logical drives to all connected servers
D. to prevent ISLs from fabric reconfiguration
E. to associate connections to logical drives
Answer: ACE
10. How can you obtain the management port IP address on an MSA1510i storage system?
A. from the OCP display on the controller
B. from the RESCAN button in the Storage Management Utility (SMU)
C. from the label on the circuit board of the Ethernet iSCSI I/O module
D. from the two rightmost digits of the controller's serial number, added to "10.0.0."
Answer: A

WWW.PASS4SIDE.COM